3U Eurorack module,
14HP wide,
20mm deep
Weight 0.5 kg
current draw: 50mA
How to use Cwejman Ribbon cable connectors
User manual MMF-6
The MMF-6 is a multi mode filter with six outputs, first three from the left; “clean” low pass, band pass and high pass. Low- band- and high pass to the right are processed by three separate (for every output) saturation circuits with two modes; soft and hard. Additionally, the filter core has so called “symmetry” control for the resonance and cutoff frequency. It is possible to control cutoff so positive and negative going signals has different cutoff frequencies, from a subtle “edge” to very dramatical character of the audio signal (including frequency division effect). All this by modulating symmetry by one of outputs (pre-patched to “clean” low pass output) or an external signal. Now it is possible to mix clean and saturated audio signals in any combination.
Inputs:
Audio: 2x In
CV inputs: 2x cutoff, 1x Q-peak, 1x symmetry
Outputs:
clean LPF, BPF and HPF
saturated LPF, BPF and HPF
dimensions
(filter1,2,3,4)
3U Eurorack module
46HP wide
20mm deep ( behind the front panel )
Weight 0.9 kg
power consumption: 190mA
How to use Cwejman Ribbon cable connectors
Master section ( CUTOFF, WET, LEVEL, MIX )
QMMF-4 contain of 4 individual filters which can be controlled separately and by
the master controls.
CUTOFF Hz : 16Hz – 16kHz
FINE TUNE : for fine tuning of cutoff frequency
Q-PEAK : resonance control of the filter from flat to self oscillating mode in OSC SAT or OSC position and there is RES mode as a resonator.
OUTPUT FADER : volume control of the filter’s output. There are 2 outputs ( PRE, POST ) . PRE is the direct output from the filters, POST is the attenuated output controlled by OUTPUT FADER and by external signals inserted to LEVEL inputs.
INPUT LEVEL : audio input manual controller.
3 Filter mode (HP: High pass , BP: Band pass ,LP :Low pass ).
NOTCH output : a sum of lowpass and high pass.
AUDIO INPUTS : individual audio inputs for all filters, pre-patched to the master control but can be used for four external sound sources.
CM1 : cutoff modulation with manual BIPOLAR level control for the inserted external modulation signals.
CM2 CAL: input for external modulation source and calibrated for 1 volt per octave.
Q-PEAK : manual and voltage controlled amount of filter resonance.
LEVEL : controlled the outgoing level of the filters (POST ) manually and by external signals.
MASTER SECTION :
CUTOFF : controls all 4 filter cut offs
WET LEVEL : controls all 4 filter volumes
MIX : controls the mix of dry and wet signals.
Master section has 2 audio outputs (NOTCH and MMF )
NOTCH : it is different from other filter notches, it is the sum of all 4 filters but with inverted phases of F2 and F4.
MMF: it is the sum of all 4 filters. It creates pseudo stereophonic effect.
Master section’s CV controls
FREQ : cutoff frequency, calibrated for all filters for 1 volt per octave.